Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - grizzz66

Pages: [1]
1
Hand Tool Woodworking / Re: Cap Iron Plane Screwdriver
« on: April 04, 2011, 12:04:55 am »
hi all ,

  that cap iron trick works with the stanley/baileys/bedrocks....i don't know if it works with LV planes....i probably shoulda thought of that before  ::)

2
Hand Tool Woodworking / spoke shave blades
« on: March 20, 2011, 07:22:20 pm »
hey everyone ,  just a quick question about spokeshave blades .  is there a specific jig to use for that on my tormek ? if there is i don't have it , YET !   ;)

3
Hand Tool Woodworking / Re: Cap Iron Plane Screwdriver
« on: March 20, 2011, 07:17:09 pm »
hi guys ,  the cap iron itself is designed to remove the screw holding the chip breaker to the blade, no special screwdrivers needed  ;)  with that said, i do really like lee valley and have been ordering from them for many years ...... i just figured i would post this so you can save your money for other lee valley stuff  ;D

4
General Tormek Questions / Re:Brands of mineral oil for honing wheel ?
« on: November 14, 2004, 09:41:03 pm »
hey there in the uk  :)

 you should be able to find mineral oil in the grocery store.  its used on wooden cutting boards all the time to recondition them

5
General Tormek Questions / Re:comparison with Veritas
« on: January 02, 2004, 04:07:28 am »
just my two cents , but i dont think you can do any better than a tormek , i have been an owner of both systems and the tormek is a hands down better product !!!!  i haven't practiced alot yet but i get truely  scary results  every time, to the point if i slip and drop the tool .......... LET IT GO ! dont try to catch it !!! its easier to put a new edge on than to clean up the lost blood  ;)

6
General Tormek Questions / Re:problem sharpening chisels
« on: January 02, 2004, 03:59:44 am »
hey eric i am having the same problem ! my pal wasn't  to pleased with me, as it was a brand new set of chisels but i told him i would straighten em out as soon as i find out whats up with this . if you hear anything b-4 me  email me will ya ....  thanks grizzly

Pages: [1]