Messages

1

Wood Turning / Re: Svd 185 will not let me stay on grindstone when doing a 1/2 Ellsworth grind

« on: December 18, 2009, 09:36:21 pm »

Yes protrusion is at 75mm. The guide on the svd 185 needs to be reversed? It is the guide on the 185 that's stopping me to get closer when it is sliding on the tool rest. The tool rest is in the lower position grind stone going away from tool. When tool  handle goes left the sharping end starts at approx. 3/4 from edge of grind stone to continuing the sharping tip leaves the grind stone. At approx. 45% the handle i should stop but the wing is not sharpened complete. Doing something wrong??

2

Wood Turning / Svd 185 will not let me stay on grindstone when doing a 1/2 Ellsworth grind

« on: December 17, 2009, 08:01:17 pm »

I have a new SVD185 with a six on the dail. My stone is 8 5/8" arm is 1 5/8" away from grindstone. When bowl gouge handle goes left, gouge end starts going off the right side of grindstone. Can you help?