In the Shop > General Tormek Questions

SVD-110 Toolrest

(1/1)

Woody 01:
     has anyone made a SVD-110 Toolrest   so that a mitre gauge can be use as i have larger skew chisels, and can not hold them at the right angle and move across stone help needed

Jeff Farris:
Why not use the SVS-50 jig, which is purpose built to sharpen skews?

Woody 01:
my skew chisel is to large to fit svs-50 jig

Jeff Farris:
I see. Then I might suggest a small piece of plywood, about the size of the SVD-110, with a 1/2" square piece of stock attached to the back so that it will hang on the SVD-110, and then a piece attached to the top at the proper skew angle. Make two, one for each side.

Woody 01:
will give that a try many thanks ray

Navigation

[0] Message Index