« previous next »
Pages: [1]   Go Down

Author Topic: SVD-110 Toolrest  (Read 739 times)

Offline Woody 01

  • Newbie
  • *
  • Posts: 5
    • View Profile
SVD-110 Toolrest
« on: May 22, 2012, 05:31:32 pm »
     has anyone made a SVD-110 Toolrest   so that a mitre gauge can be use as i have larger skew chisels, and can not hold them at the right angle and move across stone help needed
Logged

Offline Jeff Farris

  • Forum Administrator
  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1122
  • Moderator
    • View Profile
Re: SVD-110 Toolrest
« Reply #1 on: May 24, 2012, 11:37:54 am »
Why not use the SVS-50 jig, which is purpose built to sharpen skews?
Logged
Jeff Farris

Offline Woody 01

  • Newbie
  • *
  • Posts: 5
    • View Profile
Re: SVD-110 Toolrest
« Reply #2 on: May 28, 2012, 08:06:16 am »
my skew chisel is to large to fit svs-50 jig
Logged

Offline Jeff Farris

  • Forum Administrator
  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1122
  • Moderator
    • View Profile
Re: SVD-110 Toolrest
« Reply #3 on: May 29, 2012, 02:47:46 pm »
I see. Then I might suggest a small piece of plywood, about the size of the SVD-110, with a 1/2" square piece of stock attached to the back so that it will hang on the SVD-110, and then a piece attached to the top at the proper skew angle. Make two, one for each side.
Logged
Jeff Farris

Offline Woody 01

  • Newbie
  • *
  • Posts: 5
    • View Profile
Re: SVD-110 Toolrest
« Reply #4 on: May 30, 2012, 07:32:31 am »
will give that a try many thanks ray
Logged
Pages: [1]   Go Up
« previous next »