Topic: Difference between US-103 and US-105

[HerrHedeblom]

Hello!

I am upgrading my 1200 with a few things, one being a new universal support.
I figured the US-103 was the way to go, but a big Swedish reseller has the US-105 listed as a spare part for the T-3 as well as the T-7.

So my question is: What's the difference between the two?

/pelle, sweden.

[Jeff Farris]

The US-105 will fit a 1200, but it will allow a tool in the SE-76 jig to slip off the edge of the grindstone before it hits the stop. You need the US-103 if you are going to use the stop.

[HerrHedeblom]

Lovely!

Since I already ordered the 105 this was great news. Thank you!

[HerrHedeblom]

OK!

I got the US-105, but I thought that it was bundled with a horizontal base. So I ordered the BGM-100 to get both a US-105 and the XB-100. However, I got no instructions on how to properly fit the base on my 1200.

Where can I find such instructions?

/pelle, sweden.

[Jeff Farris]

You can find them right here:

http://www.tormek.com/en/spare_parts/

Go to the XB-100 listing and the link to the instructions is at the end of the description.

[HerrHedeblom]

Go figure

Thank you!