Author Topic: XB-100 Horizontal Base  (Read 931 times)

Offline kb0rvo

  • Sr. Member
  • ****
  • Posts: 271
  • Jesus is Lord!
    • View Profile
XB-100 Horizontal Base
« on: April 04, 2013, 12:03:48 am »
Has the machined version of the XB-100 Horizontal Base always had 2 locking knobs or was there an earlier version with 1 knob?

Sorry, I meant to post this in the general topic area. ::)
« Last Edit: April 04, 2013, 12:06:22 am by kb0rvo »
Elden

Offline Jeff Farris

  • Hero Member
  • *****
  • Posts: 1273
    • View Profile
Re: XB-100 Horizontal Base
« Reply #1 on: April 04, 2013, 02:51:11 pm »
Working strictly from memory, there have been three versions of the XB-100.  The original was an extrusion with a single lock. The second was an extrusion with double locks. The third and current is cast and machined with double locks. There might have been two versions of the extruded with double locks, but if so, one of them was very short lived.
Jeff Farris

Offline kb0rvo

  • Sr. Member
  • ****
  • Posts: 271
  • Jesus is Lord!
    • View Profile
Re: XB-100 Horizontal Base
« Reply #2 on: April 04, 2013, 04:31:10 pm »
Thank you Jeff for the reply and answers. Also, thanks for moving the post. I wasn't paying close enough attention.
Elden