Tormek Community

In the Shop => General Tormek Questions => Topic started by: Ken S on January 12, 2019, 11:40:15 pm

Title: reusing ACC
Post by: Ken S on January 12, 2019, 11:40:15 pm
Just before Christmas, I sharpened a few turning tools with the diamond wheels and ACC. I lowered the trough in my T8, planning to do some more sharpening the next day. I was not feeling quite right.

Two nights later I was in the ER and spent much of the week in the hospital. My heart stabilized and I was back home. I felt OK, but did not have much energy. I ended up not going down to my shop until this afternoon. The water with ACC had evaporated, leaving a greasy surface. A couple paper towels followed by some hot water and Dawn made the water trough clean and like new again.

In the future, I will remove the water from the trough with my turkey baster and leave it is a sealed plastic peanut butter jar, ready (hopefully) for the next sharpening session. (Trough wiped out,  rinsed and dried.)

Title: Re: reusing ACC
Post by: Rem on January 13, 2019, 02:24:10 pm
Hey, what's with this ER stuff?   :-\ Hope you're feeling better now.   Don't make me have to come down there.  It's so damn cold, I can't even start my truck.  GET RIGHT, SAILOR.   All the best.   Rem
Title: Re: reusing ACC
Post by: Ken S on January 13, 2019, 04:07:54 pm
Thanks, Rem. If I ever get in a jam, you and Rex will be my first call!