Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jonj

Pages: [1]
1
Cliff, as an owner of a 1996 Super Grind 2000, I agree with all the suggestions you have received about upgrades. Over the years, I have added the threaded universal support with micro adjust, horizontal universal support base, stainless steel shaft and EZ nut, updated angle finder, and after reading here just a few days ago about Super Lube, obtained a tube and did a clean and relube of my machine yesterday. It is still working great. And then there are the jigs (and improved jigs) as applicable.

Having just found this site a few weeks ago, I have been going through the threads and find I am learning a significant amount which will improve my sharpening skills (and also correct a large number of bad habits which have unfortunately crept into my work process over the years). In my opinion, you have found the right place for Tormek information.
Jon

2
Knife Sharpening / Re: US400 Extended Universal support
« on: April 03, 2018, 07:07:07 pm »
I've used a Tormek since 1996 but just discovered this site a week ago. Does anyone know if the US 400 is still available since there were a limited number imported? Thanks.

Pages: [1]