Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - emlclcy

Pages: [1]
1
Planer Blade Sharpening / Re: straight edge blues
« on: July 31, 2020, 12:03:32 pm »
too narrow to sharpen
if you had a narrow strip to pack out the blade, is there enough material on the blade to clamp it?
If there is you could get metalsupermarket to guillotine a thin strip of aluminium. The shop nearest me - i'm assuming you are in the uk, charge 50p/cut and the metal would be pennies

2
Planer Blade Sharpening / Re: straight edge blues
« on: July 31, 2020, 11:47:44 am »
i have a milling machine and ran a dial gauge along both the sliding extrusion and the fixed steel part and they are both not exactly flat so maybe the combination of two errors and the blade at a shallow angle will cause this error. i'm going to take a very light cut off both parts where the plastic strip was glued and try again
regards
carl

3
Planer Blade Sharpening / straight edge blues
« on: July 29, 2020, 10:25:10 am »
 i have a T8 and an svh-320 planer blade jig. My planer blades are 10" x 3/4" so fit the jig well. I can true the wheel with the diamond attachment and grind a good edge on the blade BUT if i place the sharpened edge on a surface plate it is not flat. The strip of ptfe tape on the jig was bumpy and uneven so i removed that but still cannot get a straight edge.
any ideas?
regards
carl

Pages: [1]