Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - miamidon

Pages: [1]
Wood Turning / Sharpening of Roughing Gouge
« on: February 23, 2005, 04:28:04 pm »
I have used my Tormek for a couple of years for chisels, plane irons and kitchen knives, with success.  

I made my first try at using the SVS-50 with a 1-inch roughing gouge the other day.  In spite of removing all of the magic-marker coating on the bevel, I could not raise a detectable burr on the inside of the gouge.  Any clues as to what I am doing wrong here?

I note that the instructions in the book only mention honing on the leather wheel on the bevel, using a marker.  If I HAD raised a burr on the inside of the gouge, would I not want to hone that side too?


Pages: [1]