Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Nik3

Pages: [1]
1
General Tormek Questions / SVP-80 question
« on: October 01, 2019, 10:06:16 am »
Hello. Is there anyone in this forum that is using this jig? And can confirm that it is working like it should and if it can be used to sharpen sheep shears and other cutting machine?
Is the standard pin system enough or should it be more hole to be acceptable for more sizes?
Have got more and more questions if I can sharpen this kind for the local community and that's why I'm asking for more knowledge!

Best regards
Nik3

Pages: [1]