Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Mickey

Pages: [1]
Planer Blade Sharpening / Planer blade minimum width
« on: July 30, 2018, 03:36:14 pm »
The SVH-320 planer blade attachment instructions state the minimum blade width is 13mm or a hair over 1/2 inch. Is there any workaround for that to accommodate a 7/16ths inch wide blade, or is the 1/2 inch minimum a hard stop to keep the lower edge of the grinding jig support slightly off the wheel?

Thank you.


Pages: [1]