Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Nik3

Pages: [1]
General Tormek Questions / SVP-80 question
« on: October 01, 2019, 10:06:16 am »
Hello. Is there anyone in this forum that is using this jig? And can confirm that it is working like it should and if it can be used to sharpen sheep shears and other cutting machine?
Is the standard pin system enough or should it be more hole to be acceptable for more sizes?
Have got more and more questions if I can sharpen this kind for the local community and that's why I'm asking for more knowledge!

Best regards

Knife Sharpening / Re: Frontal Vertical Base
« on: July 05, 2019, 09:41:22 am »
Thank you wootz, great reading like normally.

So I should start with a low deburring angle (0.5°?) And then test with the flourocarbon.
What jumps do you recommend to take between each increase?
And if it goes to high and round the Apex then it will just not cut as easily anymore?

Knife Sharpening / Re: Frontal Vertical Base
« on: July 04, 2019, 11:20:38 pm »
Hello fellow tormeker

Im wondering on how can I tell if I have deburred the bevel ?
I don't have edgeonup. So can't get help From it.
Is it just to test one angle first and if not working then try an even greater angle?
Is there any "easier" way to know at what angle to deburr it other then trial and error?

Best regards

Knife Sharpening / Re: Tormek SG & leather wheel - razor sharp
« on: June 10, 2019, 02:19:42 pm »
Hello. First Time poster.
IF i have used the black marker method to get the same angle for The knife on the sharpening Stone, how can i change the lenght of the legs of the USB so that i can Quickly change from Stone to leather wheel?

Best regards

Pages: [1]