Author Topic: Sharping Ultra Premium Steels  (Read 693 times)

Offline brute

  • Newbie
  • *
  • Posts: 9
  • I'm a sharp craftsman!
    • View Profile
Sharping Ultra Premium Steels
« on: May 25, 2020, 02:39:59 pm »
I have a question, anyone have experience sharping ultra premium steels? Like Maxamet, S110V, S90V, Elmax. Are CBM wheels good, or are Diamond wheels better?

Offline Josu V

  • Jr. Member
  • **
  • Posts: 89
  • I'm a sharp craftsman!
    • View Profile
Re: Sharping Ultra Premium Steels
« Reply #1 on: May 25, 2020, 08:48:16 pm »
Both kind of wheels are adequate for Premium Steels.

I have used both wheels for VGMax and S90V and I have obtained very good results.

(I understand where you write CBM you want write CBN)


Regards
« Last Edit: May 25, 2020, 08:55:38 pm by Josu V »
Abusus non tollit usum

Offline brute

  • Newbie
  • *
  • Posts: 9
  • I'm a sharp craftsman!
    • View Profile
Re: Sharping Ultra Premium Steels
« Reply #2 on: May 25, 2020, 10:55:15 pm »
Josu
My bad, typo error. Thanks for your reply.

Offline RickKrung

  • Hero Member
  • *****
  • Posts: 944
  • Maker
    • View Profile
Re: Sharping Ultra Premium Steels
« Reply #3 on: May 26, 2020, 12:16:48 am »
If you have not already, you should avail yourself of Knife Grinder's work on sharpening all sorts of knives.  Best info I know of.

Deburring Book
Quality is like buying oats.  If you want nice clean, fresh oats, you must pay a fair price. However, if you can be satisfied with oats that have already been through the horse, that comes at a lower price.