Author Topic: Replacement of knob  (Read 3288 times)

Offline Sharpco

  • Sr. Member
  • ****
  • Posts: 413
    • View Profile
Re: Replacement of knob
« Reply #15 on: September 17, 2019, 01:32:02 am »
Maybe it will be off topic, but which sharpening angle do you use? to have this kind of problem.

It depends on width. Generally over 20 degrees.

Offline mat450

  • Newbie
  • *
  • Posts: 14
  • I'm a sharp craftsman!
    • View Profile
Re: Replacement of knob
« Reply #16 on: September 25, 2019, 12:24:01 pm »
when you flip the jig to when the knob faces down, using sharpy mark position of jig on blade, then undo jig and flip so knob is facing upwards and tighten jig same place on blade.

I do this method on thick blades to get even bevels