Author Topic: SJ-250 for sharpening ornamental turning cutters  (Read 726 times)

Offline RichColvin

  • Hero Member
  • *****
  • Posts: 724
  • Ornamental Turner
    • View Profile
    • SharpeningHandbook.info
SJ-250 for sharpening ornamental turning cutters
« on: February 24, 2020, 04:08:26 am »
In ornamental turning, it is vital that the cutters be sharpened to a mirror finish. 

Jon Magill wrote a really great article for the Spring 2008 edition (Vol 23, #1) of AAW's "American Woodturner". In the article titled, Build an Overhead Drive (pages 30-31), he wrote:

Quote
Cutters must be sharp! You will never achieve a reflective cut off the tool, which is always the goal in OT, if your cutter isn’t sharp. I once read that you can never get a better finish off of your tool than the finish on the tool itself. In other words, unless your cutter has a mirror finish, you cannot expect to produce a mirror finish on your work.

The attached picture shows the results of sharpening my cutters with the SJ-250.  By the way, there is no sanding here -  this is straight off the rose engine lathe.

Kind regards,
Rich
« Last Edit: February 24, 2020, 04:11:27 am by RichColvin »
---------------------------
Rich Colvin
www.SharpeningHandbook.info - a reference guide for sharpening
www.ColvinTools.com

You are born weak & frail, and you die weak & frail.  What you do between those is up to you.

Offline Ken S

  • Moderator
  • Hero Member
  • *****
  • Posts: 6890
    • View Profile
Re: SJ-250 for sharpening ornamental turning cutters
« Reply #1 on: February 24, 2020, 01:07:56 pm »
Very good post, .rich.

Ken