Author Topic: Angle master wm 200  (Read 188 times)

Offline numpty

  • Newbie
  • *
  • Posts: 1
  • I'm a sharp craftsman!
    • View Profile
Angle master wm 200
« on: September 21, 2020, 02:30:25 pm »
 New to forum and woodworking, plus using Clarkes 8"  wet wheel grinder Tormek unaffordable,, Aaaaah shame!, not all at once please.
ikely wrong place but here goes.
I recently purchased a Tormek Angle master wm-200 and it has two angle sales  one above the other , The lower scale is 10-75°  and upper scale mb-100  0-55°.
I am using the lower scale ready to sharpening both chisels and a plane blade.angle seems right.  No YouTube demo video or instructions on box refer to top scale.
Curiosity has the better of me what top scale is for. I think Have the right forum name.
Thanks in advance :D

Offline cbwx34

  • Hero Member
  • *****
  • Posts: 1566
  • Question Everything
    • View Profile
Re: Angle master wm 200
« Reply #1 on: September 21, 2020, 02:37:29 pm »
New to forum and woodworking, plus using Clarkes 8"  wet wheel grinder Tormek unaffordable,, Aaaaah shame!, not all at once please.
ikely wrong place but here goes.
I recently purchased a Tormek Angle master wm-200 and it has two angle sales  one above the other , The lower scale is 10-75°  and upper scale mb-100  0-55°.
I am using the lower scale ready to sharpening both chisels and a plane blade.angle seems right.  No YouTube demo video or instructions on box refer to top scale.
Curiosity has the better of me what top scale is for. I think Have the right forum name.
Thanks in advance :D

It's for setting the angle using the MB-100... which is used to sharpen on the flat side of the diamond wheel.

You can read about it here....  https://www.tormek.com/media/1911662/hb-10-en-v104-mb-100.pdf