Author Topic: Pfeil 25/10 Backbent Gouge Sharpening  (Read 828 times)

Offline donaldeverett

  • Newbie
  • *
  • Posts: 2
  • I'm a sharp craftsman!
    • View Profile
Pfeil 25/10 Backbent Gouge Sharpening
« on: October 27, 2020, 01:00:13 pm »
I need help on how to sharpen this gouge.  I cannot find any type of setup or jig that will allow me to sharpen the tool.  I have tried multiple projections and setting and none will allow for a 20 degree approach to the wheel.  Can someone send a picture or setup and jig to use?

Offline micha

  • Jr. Member
  • **
  • Posts: 83
    • View Profile
Re: Pfeil 25/10 Backbent Gouge Sharpening
« Reply #1 on: October 27, 2020, 01:45:26 pm »
Donald,
I'd try that with the SVS-38, probably clamping it on the straight part (after the backbent part). With enough distance from the USB, I can't imagine why it shouldn't work.
How did you try and which jigs did you use?
Mike

Offline cbwx34

  • Hero Member
  • *****
  • Posts: 1631
  • Question Everything
    • View Profile
Re: Pfeil 25/10 Backbent Gouge Sharpening
« Reply #2 on: October 27, 2020, 02:21:09 pm »
I need help on how to sharpen this gouge.  I cannot find any type of setup or jig that will allow me to sharpen the tool.  I have tried multiple projections and setting and none will allow for a 20 degree approach to the wheel.  Can someone send a picture or setup and jig to use?

All I found was what's in the manual...



Link to the manual...
https://www.tormek.com/media/448711/hb-10-en-v101-svd-185.pdf
« Last Edit: October 27, 2020, 02:22:53 pm by cbwx34 »
Knife Sharpening Angle Calculators:
Calcapp Calculator-works on any platform
or, a couple of iOS Calculators

Offline donaldeverett

  • Newbie
  • *
  • Posts: 2
  • I'm a sharp craftsman!
    • View Profile
Re: Pfeil 25/10 Backbent Gouge Sharpening
« Reply #3 on: October 30, 2020, 09:13:05 pm »
See attached.  How do I get to the 20 angle I need.  I cannot figure out how to manipulate the tool and jig to get to the grind angle.

Offline micha

  • Jr. Member
  • **
  • Posts: 83
    • View Profile
Re: Pfeil 25/10 Backbent Gouge Sharpening
« Reply #4 on: October 30, 2020, 09:48:44 pm »
Donald,

Your approach seems ok. If there is still a usable edge, you could replicate it with the help of a sharpie marker.

Giving exact values for distances is difficult without having the exact geometry of the tool. (But it's not impossible.)

Mike

Edit: sorry for having written some nonsense before, after a closer look I found my mistake...
« Last Edit: October 30, 2020, 10:00:39 pm by micha »