Author Topic: Angle Setting Jig for the SVD-110  (Read 1171 times)

Offline Ken S

  • Moderator
  • Hero Member
  • *****
  • Posts: 6925
    • View Profile
Re: Angle Setting Jig for the SVD-110
« Reply #15 on: November 20, 2020, 05:35:06 pm »
I like JVH's simple modified kenjig idea. I believe the future will see even more of us increasingly using diamon and/or CBN wheels which do not change diameter. Hopefully we are mostly beyond the nonsense of 253mm diameter wheels, which I believe are really ten inch, a mistake for a metric machine.

I also believe wheel wear with knives is overblown. Yes, conventional wheels do wear. However, the bevel angle of scrapers is not critical. Worst case scenario, the simple jig will get you very close. Using the black marker should cover the fine tuning.

Ken

Offline Dutchman

  • Full Member
  • ***
  • Posts: 112
  • Ton N.
    • View Profile
Re: Angle Setting Jig for the SVD-110
« Reply #16 on: November 21, 2020, 11:34:31 am »
Hey Ton!

You finally made it! 🤣
🥳 🥳 🥳 🥳 🥳
Yes! Thanks. Finally succeeded.
Promise for a bright future.  8)

Offline Ken S

  • Moderator
  • Hero Member
  • *****
  • Posts: 6925
    • View Profile
Re: Angle Setting Jig for the SVD-110
« Reply #17 on: November 22, 2020, 04:00:42 am »
Dutchman,

If your future is as bright as your past contributions, we will continue pushing back the frontiers of sharpening knowledge.

Your grinding angles booklet is the the inspired spark for all of our advancements in knife set up. (It will be a very hard act for you to follow!)   :)

Thank you, Ton.

Ken

Offline Dutchman

  • Full Member
  • ***
  • Posts: 112
  • Ton N.
    • View Profile
Re: Angle Setting Jig for the SVD-110
« Reply #18 on: November 22, 2020, 12:24:17 pm »
Thank you for the praise  ;)