Drill Bit Sharpening

Drill bit sharpening with DBS-22

Flexibility and Precision

4 Facet Point 500

4-Facet point

The chisel edge comes to a point and will not walk. Bores a round, straight hole with close tolerances.

  

All -point -angles -200x 155

Always equal cutting edges

The two cutting edges are sharpened symmetrically and work in perfect unison which prolongs the life of the drill.

 

All -point -angles -200x 155

Sharpens all point angles

It can be set at any angle between 90° and 150°. 

 

Always The Right Clearance Angle 500

Always the right clearance angle

The optimal clearance angle can be set according to each drilling requirement to 7°, 9°, 11° or 14°.

 

Sharpens All Drill Sizes 500

Sharpens drill bits from 322 mm 

One and the same drill holder copes with sizes between 3 mm (1/8") and 22 mm (7/8"). No change of chuck required.

 

Questions & Answers

Why is the 4-facet point so beneficial compared to a conventional point?

It considerably decreases the force required on the core of the drill, i.e. the chisel edge, which reduces the heat development and permits an increased force to the cutting edges. It gives the drill a dramatic improvement in cutting performance.

Why does a Tormek sharpened drill last longer?

The beneficial 4-facet point and the high precision sharpening – both cutting edges are sharpened to an exact equal length and symmetrically – make the drill work efficiently and the life of the drill bit is considerably prolonged.

What determines an exact and straight hole?

The 4-facet geometry causes the drill to bore a straight and round hole with very close tolerances. It is crucial that both cutting edges are equal and sharpened to the same angle. This is an essential requirement so that the two edges will work in the same way and ensures that the drill will bore a straight hole, which is not larger than the drill diameter. Otherwise, the longer edge will take most of the cutting force, get overheated and more heavily worn. The result is a drill that will dull rapidly and stop working properly.

What point angle should I have?

Drill bits usually have a point angle of 118° or 130°. Hardened steel and stainless steel require larger point angles. Also aluminium is best drilled with a larger point angle. When drilling plexiglass, the risk of cracks when the drill goes through the material is reduced with a larger point angle. Centering drills usually have a 90° point angle.

Is the clearance angle important?

The choice of clearance angle is crucial to the cutting performance and duration of the drill. The optimal clearance angle depends both on the drill diameter and the material to be drilled. A harder material requires a drill with a smaller clearance angle while a softer material can have a larger angle. Standard drills have a clearance angle of 11° and a 118° point angle which work well for most drilling work.

How do I know if the steel has become overheated when using a dry grinder?

Overheating of the steel is often not noticeable, but the consequences are that the drill will dull rapidly and may even break. Unlike conventional drill bit sharpeners, Tormek sharpens with water cooling which is gentle on the steel.

Where can I see how it works?

Watch the short step by step film demonstration (4:19) on the DBS-22 product page. There you will also find a film made by Alan Holtham where he tries out the jig.

 


Go to DBS-22 Drill Bit Sharpening Attachment DBS-22 Drill Bit Sharpening Attachment

DBS-22 Drill Bit Sharpening Attachment

Go to RB-180 Rotating Base

RB-180 Rotating Base

Machine Models